§3. Flight Manual
§3-2. ランプスタート
2) エンジン始動後チェック（つづきの2） 『Main Checklists.pdf』 Page：6～7/16
引き続き、離陸に向けて各機器のチェック及び設定を行います。
- (17) DBU CHECK (AFTER FLCS BIT completed)
- - DIGITAL BACKUP switch: BACKUP
- - DBU ON warning light: Verify ON
- - Operate controls: All surfaces respond normally
- - DIGITAL BACKUP switch: OFF
- - DBU ON warning light: Verify OFF
- (18) TRIM CHECKS
- - TRIM AP DISC switch: DISC
- - Stick TRIM buttons: Activate in ROLL and PITCH No control surface, no indicator motion
- - TRIM AP DISC switch: NORM
- - Stick TRIM buttons: Check and centre Control surface & indicator motion
- - Rudder trim check: YAW TRIM knob: Check and centre
- (19) AIR REFUEL CHECKS
- - AIR REFUEL switch: OPEN CHECK RDY light ON, DSC light OFF
- - A/R DISC button: Depress DSC light ON; RDY Light OFF then 3sec later, RDY light ON, DSC light OFF
- - AIR REFUEL switch: CLOSE
- (20) EPU CHECK
- - EPU GEN and EPU PMG lights: Confirm OFF
- - O²: 100%
- - Toe brakes: Engage
- - EPU switch: OFF
- - EPU switch: NORM
- - THROTTLE: 80%
- - EPU/GEN TEST switch: EPU/GEN and hold. Check lights: EPU AIR light ON EPU GEN and EPU PMG light OFF FLCS PWR lights ON EPU RUN light ON within 5 seconds
- - EPU/GEN TEST switch: Release (OFF)
- - THROTTLE IDLE
- - O²: NORMAL
- (21) OBOGS CHECK (At least 2 minutes after engine start)
- - OBOGS BIT switch: BIT
- - VERIFY LIGHT: OXY LOW (right brow) ON for 10sec then OFF
- - Pressure: CHECK 25-40 PSI
- - Mode Lever: PBG/ON (as required)
- - Diluter lever: NORM
- - EMERGENCY lever NORM
- - FLOW indicator Check
